Overview
This tape applicator was built to order for one customer's flat parts. An aluminium gantry spans a fixture table on a closed steel base; the tape head travels along the gantry, and its wide multi-roller head presses wide tape or film across the part.
A cable carrier guides the cables and air lines of the moving head, a touchscreen on a post controls the machine and an emergency stop sits on the front of the base. A separate belt conveyor at the end of the machine takes finished parts away, so the machine can pass parts straight on to the next step.
Table size, head width, gantry travel and the conveyor are all made to your parts. If you need wide tape or film on flat parts and no standard model fits, send us a drawing or samples.
How it works
- 1 Place the part on the fixture table.
- 2 Start the cycle on the touchscreen.
- 3 The head travels along the gantry and rolls wide tape or film onto the part.
- 4 Finished parts go onto the outfeed conveyor and on to the next step.
Key advantages
Wide multi-roller head
Several rollers across the head press wide tape or film flat over the full width of the part.
Gantry-mounted head
The head travels on a gantry above the fixture table for a straight, even run of tape or film.
Fixture table
Parts are placed in a fixture on the table, so each one sits in the same position under the head.
Outfeed conveyor included
A belt conveyor at the end of the machine takes finished parts away and can link the machine to your line.
Touchscreen and emergency stop
Cycles are started and set on a touchscreen; an emergency stop is on the front of the base.
Made to order
Table size, head width, gantry travel and conveyor length are designed for your parts.
Technical specifications
| Item | Specification |
|---|---|
| Applicable products | Flat parts that need wide tape or film |
| Machine layout | Gantry with a wide multi-roller head over a fixture table; separate outfeed belt conveyor |
| Control | Touchscreen and emergency stop |
| Customization | Table size, head width, gantry travel and conveyor made to order |
Not in the printed catalog — built to order
Applications
Suitable products
- Flat panels and boards
- Plastic and metal plates
- Electronic panels and housings
- Sheet parts that need wide tape or film
Industries
- Electronics
- Plastics
- Hardware
Typical scenarios
- Wide double-sided tape or protective film on flat parts
- A taping station that feeds a conveyor line
Industries: Hardware & metal partsAutomotive components All industries
Options and customization
- Table and fixture size to suit your parts
- Head width for your tape or film
- Conveyor length and height to match your line
Selection tips
- Tell us the part size, the tape or film width and where it goes; that sets the table size, head width and gantry travel.
- For protective film or tape up to 450 mm wide on a vacuum platform, see the wide-format film and tape applicator.
- For narrow tape strips at several positions, a floor-standing 2-axis or 3-axis tape applicator is usually faster.
FAQ
What is this custom wide-format tape applicator for?
Is it a standard model?
What does the outfeed conveyor do?
How wide can the tape or film be?
How fast and how accurate is it?
Published by Dongguan Yixing Automation Equipment Co., Ltd., the manufacturer of every machine shown. The content is prepared and checked by our sales team, and every specification is taken from the printed product catalog; figures that are not in the catalog are not published. Source:YIXING product catalog, PDF, 28 pages (10.5 MB). Updated:
